Synergy 5224-A - Jeep JK 4 Door Rear Cage Kit - Manual (Page 8)

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
10. Cut a hole in the roll bar padding cover where the C-pillar upright tube goes through.
Position the tube through the hole in the padding and tack weld into place.
11. Included in this kit is also a rear passenger harness bar. If desired, install at this time.
It should be positioned just about an inch below the top of the rear seat as shown to
ensure proper harness mounting points. See image 11.1 below. Be sure tube is level
with the vehicle and that the seats clear when in the fully up position. Tack weld into
position once satisfied.
Img. 11.1
12. Fully weld C-pillars and harness bar in vehicle.