Synergy 5710 - Jeep JK Standard Skid Plate User Manual
Page 10
19. Once all 3/8” bolts have been started, install the ½” flat head countersunk bolts which attach the engine skid
to the transmission skid plate. Do not fully tighten at this time.
20. Adjust the side to side position of the front engine skid and tighten all the mounting bolts. Tighten the 3/8”
bolts to 20 ft-lbs and the ½” bolts to 35 ft-lbs. Tighten in the order listed below for proper alignment of skid
plate.
3/8” bolt / flange nut on driver side to motor mount.
Motor mount bolt – torque to 45 ft-lbs
Driver side upper 3/8” bolts to bracket
Driver side lower 3/8” bolts to skid
Passenger side lower 3/8” bolts to skid
½” bolt / flange nut on passenger side to motor mount.
½” flat head countersunk bolts to trans skid.
21. Installation is Complete.