Synergy 5710 - Jeep JK Standard Skid Plate User Manual
Page 6
Advertising
REAR T-CASE SKID PLATE
12. You can now install the rear transfer case skid plate. Install the skid plate on top of the crossmember skid
plate. If desired, drill and tap the gas tank and rear frame hole to ½-20 and use the supplied flat head allen
bolts. If not use the original bolts and tighten to 35 ft-lbs.
13. Install the 3 center ½” flat head allen bolts with the flange nuts and tighten to 35 ft-lbs.
FRONT ENGINE SKID PLATE
14. Loosen the driver side engine mounting bolt and tap rearward with a hammer. Slide the engine mount
frame bracket under the bolt as shown. Attach the bottom of the bracket with a 3/8” bolt, washer, and
flange nut. Do not tighten at this time.
Advertising