Synergy 5713 / 14 - Jeep JK 2/4 Dr Gas Tank Skid - Manual (Page 10)

26. If you are using the Synergy 5710 skid plate assembly, install the three 3/8 flat head bolts with flange nuts
in the from the bottom of the gas tank skid plate
27. Connect quick-connect fittings at front of tank.
28. Connect quick-connect fitting (2), (9) and (10)
29. If you are using the stock transmission cross member, attach the 5714-11 adapter to the front of the gas tank
skid and to the stock cross member with the factory bolts.
30. Tighten the bolts that secure the skid plate to the side brackets, tighten the ½” bolts to 50 ft-lbs, tighten the
3/8” bolts to 20 ft-lbs
31. Tighten the factory frame bolts to 30 ft-lbs.
32. Install the T-case skid plate, if you are using the Synergy 5710-02 T-case skid plate, use the new ½” flat
head bolt and flange nut, if you are using the stock T-case skid, use the new supplied ½” bolt, washer and
flange nut.
33. Installation is complete.