Synergy 5713 / 14 - Jeep JK 2/4 Dr Gas Tank Skid - Manual (Page 2)

 (1) 5714-07 Gas Tank Skid Front / mid outer bracket
 (1) 5714-11 Stock Cross member adapter
 (1) Hardware kit
o (3) ½-13 UNC x 1.25” long hex head bolt
o (4) ½-13 UNC Flange nut
o (3) ½” Flat washer
o (1) ½-13 UNC x 1.25” long flat head socket cap screw
o (3) 3/8-16 UNC x 1” long flat head socket cap screw
o (8) 3/8-16 UNC Flange nut
o (5) 3/8-16 UNC x 1” long hex head bol
o (5) 3/8” flat washer
Parts / Tools Needed to complete installation:

Basic simple hand tools.

Floor Jack & jack stands / vehicle stands.

Extra person to aide in gas tank removal.
APPROXIMATE INSTALL TIME: 1-2 hours with a vehicle lift. 3-4 hours without a vehicle lift.
1. Unpack the skid plate components from boxes, verify that all parts are intact and in good condition. The
following is a list of included components:
2. Read all the following steps before beginning installation. If you do not have the proper tools or ability to
install the components properly do not attempt installation. Find a creditable, local shop to do the
installation work.
3. Drain the gas from the tank if it’s not close to empty. You can do this by removing the filler hose form the
fuel tank and inserting a drain hose, it needs to be a small hose because there is a flapper valve installed into
the opening.
4. Remove the stock T-case skid plate or any aftermarket T-case skid plate
5. Loosen and remove the passenger side rear lower control arm bolt, pull the bolt out so it is flush with the
inside of the lower control arm bracket
6. It is very helpful to remove and install the tank if you remove the right rear coil spring and disconnect the
drive shaft at the pinion
WARNING: The fuel system is under constant pressure even with engine off. Before servicing fuel rail,
fuel system pressure must be released.
7. Remove fuel fill hose clamp (2) at rear of tank (3).
8. Remove fuel fill hose (1) from fuel tank.