Synergy 5801 - Jeep JK 2/4 Dr Front Grab Handle User Manual
Page 2
Advertising
2. Remove the two vertical screws (3) that attach the windshield visors(4) Use a T-15 Torx bit for removal.
3. Remove the A-pillar trim (2). Remove the push pin fastener (6) by unscrewing the center with a phillips
head screw driver, then pull the push pin out. Pull the retaining clip (3) using a trim stick or equivalent tool.
4. Remove the side bar padding cover.
5. Remove the lower side bar bracket bolt in the windshield. Use a 13mm socket.
Advertising