Synergy 5801 - Jeep JK 2/4 Dr Front Grab Handle - Manual (Page 8)

12. Slip the J-Hook side of the grab handle through the hole cut in step 8. Slip from the back / inside of the A-
pillar trim. See image below.
13. Install the grab handle and A-pillar trim simultaneously.
14. Begin by bolting the grab handle to the windshield using the factory bolt removed in step 5. Do not fully
tighten at this time, simply snug into position.
15. Fasten A-pillar trim back to the vehicle by lining up the push-pin locations and pressing into position.
Reinstall push-pin fastener #6 and corresponding screw insert which was removed in step 3.