Synergy 8012-13 - Jeep JK Weld-On Front Track Bar Bracket User Manual
Page 11
Advertising
12. Clean the welds and paint the track bar bracket and axle tube.
13. Attach the track bar and steering stabilizer or hydro ram.
14. If you want to relocate the sway bar tab to the upper mounting hole in the track bar
bracket you will need to weld on the driver side sway bar relocation bracket. This is
required if you are using a sway bar disconnect system with pins. Using a 1 1/2” long
spacer or sway bar link, bolt the sway bar relocation bracket to the stock sway bar tab,
then weld on.
Installation is Complete
Advertising