Smittybilt 7700 Receiver Rack - Manual (Page 2)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd,Compton CA 90220
Installation Instructions
Receiver Rack (Part # 7700)
Universal Application
Step 1: Connect the two racks together by attaching the two plates to the outside of the racks using the (12)
6mm “Small” bolts, (12) 6mm flat washers and (12) 6mm lock nuts. (Fig 1)
(Figure 1)
Step 2: Tighten all bolts installed in Step1. Now locate the (3) holes down the center of the rack.
Step 3: Slide the drawbar under the rack and attach by inserting (1) “Large” 10mm x 75mm bolt, washer and
lock nut into the center hole only. (Fig 2, 3)
(Small) 6mm Bolt
& 6mm Washer
6mm Lock Nut
Receiver Rack
Metal Plate
Center Hole
Large Lock Nut
Washer
Draw Bar
Receiver Rack
Large Bolt
Figure 2
Figure 3