Smittybilt 7700 Receiver Rack - Manual (Page 3)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd,Compton CA 90220
Installation Instructions
Receiver Rack (Part # 7700)
Universal Application
Step 4: Place the curved support bars on both sides under the drawbar. Insert the “Large” bolts
through the remaining two outside holes through the rack, drawbar and the curved support bars.
(Fig 4) Attach using the “Large” washers and nuts. Do not tighten completely at this time.
(You may refer to Figure 3 for proper attachment.)
Step 5: Insert the “Medium” 10mm x 25mm bolt through the rack and ends of the curved support bar.
Attach with “Large” washer and lock nut. Repeat this step at each location. (Fig 4)
Receiver Rack
Step 6: Tighten all bolts at this time. Installation is now complete.
CAUTION: Ensure all Bolts and Nuts are secure and tightened prior to departure. Always secure
your cargo with some type of tie down system to ensure that cargo does not fall off the
Receiver Rack. Do not put valuables or any other items on the Receiver Rack that could be
damaged by adverse weather or road debris.
Draw Bar
Curve Bar
Medium Bolt
Large
Lock Nut
Large Bolt
Large
Washer
Large Lock
Nut
Figure 4
!