Snorkel XRT33-sn2300+CE - Manual (Page 4)

4 XRT Work Platform
C HASSIS C ONTROLS
11. Pull Chassis EMERGENCY STOP Switch
to the ON position.
12. Pull Platform EMERGENCY STOP Switch
to the ON position.
13. Turn the Platform Controls Key Switch
clockwise to ON.
14. Turn the Platform/Chassis Switch to
CHASSIS.
NOTE: If the engine is cold – Push and hold the PRE-
HEAT Button for 6 seconds before starting
engine to engage the glow plugs.
15. Push and hold the START Button to start
the engine. Release the Button once the
engine starts.
16. Push the THROTTLE Button in, and push
the RAISE Button to elevate the platform
until the Scissor Brace can be rotated into
position as described on page 13.
17. Visually inspect the elevating assembly, lift cylinder, cables and hoses for cracked welds, loose hardware,
hydraulic leaks, loose wire connections and erratic operation. Check for missing or loose parts.
18. Remove the Scissor Brace as described on page 13.
19. Push the THROTTLE Button in, and push the RAISE button to fully elevate the platform.
20. Partially lower the platform by pushing in on the Chassis Controls LOWER button, and check operation of
the audible lowering alarm.
21. Push the Chassis EMERGENCY STOP Switch to check for proper operation. All the machine functions
should be disabled. Pull out the EMERGENCY STOP Switch to resume.
EMERGENCY
STOP
START
PRE-HEAT
THROTTLE STOP
PLATFORM/
CHASSIS
SELECTOR
SWITCH
RAISE
LOWER
Figure 1: Chassis Controls
73 XRT Work Platform
XRT33 Hydraulic Schematic - 066945-005