Aries Automotive S223041-2 - Manual (Page 3)

To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Product.
For gloss black finishes: Mild soap may be used to clean the Product.
DRIVER SIDE INSTALLATION PICTURED
Page 3 of 4 4/26/2011
Fig 1
Fig 2B
Fig 1A
Driver side front
mounting hole in
floor board
10mm Bolt tab with
plastic retainer
installed
Rear mount holes for brackets Fig 3
Fig 2 Fig 2A
Front Driver side
mount bracket
attached to 10mm
bolt tab
Secure to brace bracket
(1) 10mm bolt
(2)10mm flat washer
(1)10mm lock washer
(1)10mm Nut
Secure to bolt tab with
(1) 12mm Hex Nut
(1) 12mm Lock Washer
(1) 12mm Flat Washer
12mm bolt tab
attached to bottom
of frame rail with
plastic retainer
Driver side front brace bracket