IKA ULTRA-TURRAX Tube Drive - Manual (Page 11)

11 032008
Changes in viscosity and volume caused by processing of dispersi-
on media may cause small fluctuations in the speed of the device.
Pay attention to the ambient conditions listed in the “Technical Data”.
Position the rotating knob (B) at the
left stop before starting up.
If these conditions are met, the unit
is ready for service when the mains
plug has been plugged in.
Switching on
Press “Power” button (A)
Previous mode and time
settings will be displayed e.g.
(Factory setting: -2)
Setting Timer (Changing of modi)
Switch of the device
Minutes-mode
Press and hold “Start/STOP” button (C),
and also press the “Power” button (A)
Minutes-mode display
The time that was previously
set will be stored, e.g.
Note: max. 29 min., speed range upto 4000 min -1 .
Seconds-mode
Press and hold button “Start/Stop” (C)
and also press the “Power” button (A).
Seconds-mode display
The time that was previously
set will be stored, e.g.
Note: max. 59 sec, speed range upto 6000 min -1 .
Setting the time
The value that was previously
set will be stored, e.g.
(Factory setting: 00)
Set the tens digit Set the ones digit
using button (E) using button (D)
Attaching the tube
Fit the tube carefully and en-
sure it is properly attached.
Setting the speed
Set the desired speed in the range of 300 - 6000 min -1
using the infinitely adjustable rarotary knob (B)
Starting
Press “Start/Stop” button (C),
While the preset countdown is running,
timer display will blink
An audible signal will be given when the
countdown is complete
Commissioning
Useful facts
Power Start
Stop
0
1
2
3
4 5
6
7
8
9
Power
Start
Stop
0
1
2
3
4 5
6
7
8
9
Power Start
Stop
1 10
Power