IKA ULTRA-TURRAX Tube Drive - Manual (Page 12)

Cancelling the countdown
- Button “Start/Stop ”(C)
Switching off
- Button “Power” (A)
It is possible for the media to become jammed between the cutters.
The unit will automatically change the direction of rotation of the cutting
device up to three times in an attempt to free the cutters. The unit will
switch off automatically if this is not possible.
If the device becomes blocked on three occasions within a certain
period of time the following error message will occur:
Display
An audible signal will be given
Corrective action: Switch off the device, check contents, switch on the
device
12 032008
Error message
Power
Start
Stop Accessories
• ST-2 Tube with stirring device 2 ml
• ST-20 Tube with stirring device 20 ml
with pierceable membrane
• ST-20-M-gamma Tube with stirring device 20 ml,
-sterilized, with pierceable membrane
• ST-50 Tube with stirring device 50 ml
• ST-50-M Tube with stirring device 50 ml,
with pierceable membrane
• ST-50-M-gamma Tube with stirring device 50 ml,
-sterilized, with pierceable membrane
• DT-20 Tube with dispersing device 20 ml
with pierceable membrane
• DT-20 eco Tube with dispersing device 20 ml,
with Rotor/Stator PSU
• DT-20-M-gamma Tube with dispersing device 20 ml,
-sterilized, with pierceable membran
• DT-50 Tube with dispersing device 50 ml
• DT-50 eco Tube with dispersing device 50 ml
with Rotor/Stator PSU
• DT-50-M Tube with dispersing device 50 ml,
with pierceable membran
• DT-50-M-gamma Tube with dispersing device 50 ml,
-sterilized, with pierceable membran
• BMT-20-S Tube for grinding with stainless balls 20 ml,
with pierceable membrane
• BMT-20-S-M-gamma Tube for grinding with stainless balls,
20 ml, -sterilized, with pierceable
membrane