IKA EH 4 basic - Manual (Page 8)

perature. Otherwise, the device will begin heating up to the
last temperature to be set.
After an interruption in the power supply during the tempera-
ture control process, the device starts back up by itself.
8
EH4b 1204
Page
Guarantee 2
Safety instructions 8
Proper use 9
Unpacking 10
Commissioning 10
Installation, filling and emptying 10
Starting 10
Setting of the safety temperature 11
Maintenance and cleaning 11
Associated standards and regulations 11
Accessories 12
Technical data 12
List of spare parts EH4 basic 12
Spare parts diagram EH4 basic 19
Caution: With this equipment only media may be worked on/or
heated, whose flash point lies over the adjusted safety tempera-
ture delimination. Value for safety temperature limit see chapter
„Technical data“. Examine regulary the function of the safety
temperature limiter (see section “Setting of the safety tempera-
ture”).
The instrument may not be operated in rooms with explosion
hazard.
Never place the unit in operation without sufficient bath liquid.
Risk of burns: Danger when touching the housing
parts and the heater coils. The temperature of the
heater coils can very rise. Before placing the device
in service, please make certain that it is set to the lowest tem-
Safety instructions
Contents
= Minimum
distance to
bath vessel
= 8mm
•
• •
•
EH4 basic 1204 01.12.2004 16:55 Uhr Seite 8