IKA RCT basic - Manual (Page 14)

Page
CE - Declaration of conformaty 2
Safety instructions 14
Unpacking 16
Correct use 16
Assembling the stand 16
Operation 17
Setting operation mode 18
Setting the safe temperature limit 18
Controlling the Medium temperature limit via 19
ETS-D or Contact Thermometer
Setting the temperature control mode
20
Maintenance 20
Accessories 20
Error codes 21
Technical Data 22
Warranty 23
For your protection
• Read the operation instructions in full before starting
up and follow the safety instructions.
• Keep the operation instructions in a place where they can be
accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
• Socket must be earthed (protective ground contact).
Before starting the device for the first time, ensure that the
connector cable is suitable for the type of socket used and that
a safe protective earth connection is assured.
• Caution - Magnetism! Effects of the magnetic field have to be
taken into account (e.g. data storage media, cardiac pacemakers ...).
• Risk of burns! Exercise caution when touching the housing
parts and the heating plate. The heating plate can reach tem-
peratures in excess of 310 °C. Pay attention to the residual
heat after switching off.
• Ensure that the mains power supply cable does not touch the
heating base plate.
• Wear your personal protective equipment in accordance with
the hazard category of the media to be processed. Otherwise
there is a risk from:
- splashing and evaporation of liquids
- ejection of parts
- release of toxic or combustable gases.
• Set up the appliance in a spacious area on an even, stable,
clean, non-slip, dry and fireproof surface.
• The feet of the appliance must be clean and undamaged.
• Check the appliance and accessories beforehand for damage
each time you use them. Do not use damaged components.
• Gradually increase the speed.
• Reduce the speed if
- the medium splashes out of the vessel because the speed is
too high
- the appliance is not running smoothly
- the container moves on the base plate.
• Caution! Only process and heat up any media that has a flash
point higher than the adjusted safe temperature limit that has
been set (50 to 360 °C).
The safe temperature limit must always be set to at least 25 °C
lower than the fire point of the media used.
• Beware of hazards due to:
- flammable materials
- combustible media with a low boiling temperature
- glass breakage
Contents
Safety instructions
EN
R_HCT_042011 14