Unpacking, Drive, Motor protection – IKA EUROSTAR 100 digital User Manual
Page 6: Correct use
6
Unpacking
• Unpacking
- Please unpack the device carefully
- In the case of any damage a detailed report must
be sent immediately (post, rail or forwarder).
• Delivery scope
- a EUROSTAR overhead stirrer
- an operation instructions
- an extension arm
- a hexagonal socket screw
- a hexagon socket offset screw key
- a chuck key
(not for EUROSTAR 20 high speed digital)
- a warranty card.
Only on version EUROSTAR 20 high speed
digital:
- an R 6000 precision shaft
- an open-end wrench
- a hook spanner.
Drive
The speed can be adjusted continuously over the whole speed range with the knob (B, see Fig. 1).
Motor protection
The stirring instrument is suitable for continuous
operation. The motor current is limited electroni-
cally. The instrument has an anti-stall and anti-
overload system.
If a fault occurs, a safety circuit immediately
switches off the motor permanently through a re-
lay in the power board. A fault occurs if the safe
functioning of the instrument is compromised.
Correct use
• Use
For mixing/stirring liquids with low to high vis-
cosities by various stirring tools.
Intended use: Stand device (chuck points down)
• Range of use (indoor use only)
- Laboratories
- Schools
- Pharmacies
- Universities
This instrument is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage
supply network that also supplies residential areas.
The safety of the user cannot be guaranteed:
- If the instrument is operated with accessories that
are not supplied or recommended by the manu-
facturer
- If the instrument is operated improperly or con-
trary to the manufacture’s specifications
- if the instrument or the printed circuit board are
modified by third parties.