JLG 460SJ ANSI Service Manual - Manual (Page 113)

SECTION 3 - CHASSIS & TURNTABLE
3120788 – JLG Lift – 3-59
3. Invert Hub (1G) and press Bearing Cup (1E) into
counterbore of Hub (1G).
4. Returning the Hub (1G) to locate on the large diame-
ter end, the Output Shaft (1A) is carefully installed
into the Hub (1G).
5. The Shaft Seal (1B) is installed over the Output Shaft
(1A) and into the counterbore of the Hub (1G). Care
should be taken to insure the seal (1B) is being cor-
rectly installed (smooth face up and located just
flush with the counterbore face).
6. The Bearing Cone (1F) is an interference fit and has
to be pressed or tapped on.
7. Pipe Plugs (1J 7 1K) should be checked and/or
installed at this time in the assembly.
8. Bearing Spacer (1H) is installed around the Output
Shaft (1A) and locates on Bearing Cone (1F).