Installation, Installation -61 – JLG T500J Service Manual User Manual
Page 97
SECTION 3 - CHASSIS & TURNTABLE
3121200
– JLG Lift –
3-61
Installation
1. If removed, position the stabilizer in place on the
frame and install the pin, keeper, and bolt that con-
nects the stabilizer to the frame.
2. If removed, install the cylinder cover on the cylinder.
Using an adequate lifting device, position the cylin-
der in place on the machine.
NOTE: The outrigger cylinder weighs approximately 48 lbs.
(22 kg).
3. Install the bolt and keeper securing the pin at the
pad end of the stabilizer and install the pin.
4. Lift the outrigger cylinder slightly up out of the frame
to gain better access to the hydraulic lines running
to the cylinder. Connect the lines to the cylinder as
tagged during disassembly.
5. Install the outrigger pin and outrigger cam pin and
secure in place with the retaining clips.
6. Using the analyzer and service mode, raise the out-
rigger.
7. Function the outriggers several times to check for
proper operation and any leakage.