JLG 40H Parts Manual - Manual (Page 301)

3120241 4-13
S
E
C
T
I
O
N
4
P
L
A
T
F
O
R
M
S
SECTION 4 PLATFORMS
137 Ring, Retainer (Used Prior to March 1991) Options: 1
Not Required Machines Without Extend-A-Reach
3760237 Machines With Extend-A-Reach
0235238 ROTATOR ASSEMBLY: Ref. E
Note: For Machines Built Prior to September 1991
refer to Service Information Bulletin #91-5 for
required upgrade.
Ref.
201 3160083
Rotator Motor Assembly (See Figure 4-3 for Break-
down)
1
202 0080099 Adapter, Motor 1
203 2760064 Housing, Gear 1
204 0440134 Bearing, Sleeve 2
205 4740199 Washer, Thrust 4
206 0440120 Bearing, Thrust 2
207 2440043 Gear, Worm 1
208 3440816 Rollpin 1/4" x 1" 4
209 0080098 Adapter, Motor to Worm Gear 1
210 2440044 Gear, Worm 1
211 4740256 Washer, Thrust 2
212 0440135 Bearing, Sleeve 1
213 1760068 Disc, Brake 1
214 Not Used
215 3931010 Bolt, Socket Head #10-24NC x 5/8" 5
216 3441228 Rollpin 3/8" x 1 3/4" 2
217 3931620 Bolt, Socket Head 3/8"-16NC x 1 1/4" 2
218 4761600 Lockwasher 3/8" 6
219 3931612 Bolt, Socket Head 3/8"-16NC x 3/4" 4
220 4070585 Shim .010 A/R
221 4070586 Shim .005 A/R
222 4070587 Shim .002 A/R
223 0100019 Loctite #271 A/R
224 0100021 Primer A/R
225 2160001 Fitting, Grease - 90° 1
226 3020025 Grease A/R
PLATFORM WELDMENTS Ref.
Note: Replacement Decals Must Be Ordered Sepa-
rately - See Section 8.
Ref.
301 Low Mount Platform Options: 1
3’ x 5’ (91.5cm x 152.5cm)
3510231 Platform - Fixed Support
3510194 Platform - Rotating Support (Prior to August 1990)
3510276
Platform - Rotating Support (August 1990 to Pres-
ent)
3510254
Platform with Welded-on Bumpers (Standard Con-
trols)
3510279
Platform with Welded-on Bumpers (Hydraulic Con-
trols)
FIGURE 4-2. LOW MOUNT PLATFORM AND FOOTSWITCH INSTALLATION. (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.