JLG 460SJ Service Manual - Manual (Page 312)

SECTION 5 - HYDRAULICS
5-24 – JLG Lift – 3120895
16. Install drive spacer if applicable.
17. Install 2 7/8 in. (73 mm) seal in end cap. Carefully
place end cap on gerotor.
18. Install cap screws and seal washers (if applicable) in
end cap. Pretighten screws to 40 in-lbs (4 Nm).
Make sure seals are properly seated. Then torque
screws 235 - 250 in - lbs (27 - 28 Nm) in sequence.
Figure 5-24. Char-Lynn H Series Hydraulic Motor