JLG 800A_AJ Parts Manual - Manual (Page 190)

4-4 800A 800AJ 3121854
SECTION 4 PLATFORM
17 2080040 13 Fastener
18 4761000 4 Lockwasher 3/8in (SN 0300069000 to SN 0300068576)
19 Not Used
20 3539685 1 Plate, Latch
21 4220165 1 Stop, Gate
22 4060803 6ft/1.8m Trim
Ref CE SPEC PLATFORM ASSEMBLIES:
3510751 Ref 5ft (1.52m) (Without Mesh) 2/A
3510499 Ref 6ft (1.83m) (Without Mesh) 3/A
3510763 Ref 6ft (1.83m) (With Mesh to Mid Rail) 1/A
3510500 Ref 8ft (2.44m) (Without Mesh) 2/A
3510764 Ref 8ft (2.44m) (With Mesh to Mid Rail) 1/A
51 1 Floor Weldment Options:
4846184 5ft Platform
4845290 6ft Platform
4845289 8ft Platform
52 1 Rail Weldment - Right Side Options:
4846194 5ft Platform without Mesh
4844955 6ft Platform without Mesh
4846228 6ft Platform with Mesh to Mid Rail
4844924 8ft Platform without Mesh
4846240 8ft Platform with Mesh Mid Rail
53 1 Rail Weldment - Left Side Options:
4846195 5ft Platform without Mesh
4844956 6ft Platform without Mesh
4846229 6ft Platform with Mesh to Mid Rail
4844925 8ft Platform without Mesh
4846241 8ft Platform with Mesh Mid Rail
54 4845328 1 Rail Weldment - Back
55 4845287 1 Rail, Top
56 3900207 AR Fastener
Ref (Note: P/N 3900207 Fastener may be replaced with P/N
0641416 Bolt, P/N 4751400 Flatwasher, P/N 3311405
Locknut and P/N3300151 Acorn Type Nut. Acorn type nut is
required to meet industry safety requirements.
57 3300393 AR Collar
58 3520072 4 Plug, Cap
59 4845288 2 Gate, Lift
60 0641418 2 Bolt 1/4in-20NC x 2-1/4in
61 4740411 4 Washer, Nylon
62 3300151 2 Nut, Acorn 1/4in-20NC
63 0961845 2 Bushing
64 0641524 4 Bolt 5/16in-18NC x 3in
65 3311505 4 Locknut 5/16in-18NC
66 4751500 4 Flatwasher 5/16in
67 2080040 13 Fastener
68 4420055 7in/18cm Tape, UHMW
FIGURE 4-1. PLATFORM COMPONENTS INSTALLATION (FRONT ENTRY PLATFORM)
ITEM # PART NUMBER QTY. DESCRIPTION REV.