JLG 40RTS Operator Manual - Manual (Page 14)

SECTION 2 - PREPARATION AND INSPECTION
2-2 – JLG Sizzor – 3120825
Drive Hubs
Check oil level in drive hub by removing pipe plug and
feeling for oil level. (Contact service personnel for assis-
tance if needed.)
NOTE: Torque Hubs should be one-half full of lubricant.
Tire and Wheel Assemblies
No loose or missing lug nuts; no visible damage.
Sliding Wear Pad Blocks
No excessive wear; adequate lubrication.
Hydraulic Oil Supply
Operate hydraulic systems through one complete cycle
before checking oil level in hydraulic oil tank. Oil should
be visible in ADD sight window on hydraulic oil tank. If oil
is not visible, add oil until oil is visible in both ADD and
FULL sight windows on tank. Do not overfill tank.
Steer Cylinder
No rust, nicks, scratches or foreign material on piston rod;
no leakage.
Steer Linkage
No loose or missing parts; no visible damage.
Steer Spindle Assemblies
No excessive wear; no damage.
Control Boxes. (Console and Ground)
Switches operable; no visible damage; placards secure
and legible. Hand controller operable; no visible damage.
Battery
Proper electrolyte level; cable connections tight; no visible
damage; no corrosion at battery cable connections.
Engine
Engine oil level - full mark on dipstick; filler cap secure; air
filter secure.
Hydraulic Pump and Valves
No visible damage; no evidence of leakage; units secure.
Platform Placards
No visible damage; placards secure and legible.
Lock-Out Cylinders (If Equipped)
No rust, nicks, scratches or foreign material on piston rod;
no leakage.