JLG 40RTS Operator Manual - Manual (Page 18)

SECTION 2 - PREPARATION AND INSPECTION
2-6 – JLG Sizzor – 3120825
28. Drive Motor, Right Rear - No visible damage, no evi-
dence of leakage.
29. Drive Brake, Right Rear - No loose or missing parts,
no visible damage, no evidence of leakage.
30. Drive Hub, Right Rear - No visible damage, no evi-
dence of leakage. Drive hubs should be one half full
of EPGL SAE 90.
31. Drive Wheel and Tire Assembly, Left Rear - Properly
secured no loose or missing lug nuts, no visible
damage. Refer to inflation psi stenciled on frame or
wheel rims.
32. Sizzor Arms and Sliding Wear Pads - Properly
secured, no visible damage, evidence of proper
lubrication. Inspect sizzor arm guards for damage
and proper installation.
33. Lift Cylinder - Properly secured, no visible damage,
no loose or missing parts, no evidence leakage.
34. Safety Prop - Stored securely, no missing parts.
35. Hydraulic Pump - Pump properly secured, no visi-
ble damage, no evidence of leakage. Hoses and fit-
tings properly secured, no visible damage, no
evidence of leaks.
36. Engine Installation - Engine oil to full mark on dip-
stick, oil fillercap secure. Muffler/exhaust system
properly secured, no leakage. Air filter assembly
secure, no loose or missing parts, element clean.
Gasoline Engine Only - Radiator cap secure, cool-
ant to correct level.
37. Handrail installation - All railings securely attached,
no damage or missing parts, chains securely
attached.
38. Steer/Drive Wheel and Tire Assembly, Right Front -
Properly secured, no loose or missing lug nuts, no
visible damage. Refer to inflation psi stenciled on
frame or wheel rims.
39. Drive Motor, Right Front (4 Wheel Drive) - No visible
damage, no evidence of leakage.
40. Drive Brake, Right Front (4 Wheel Drive) - No loose
or missing parts, no visible damage, no evidence of
leakage.
41. Drive Hub, Right Front (4 Wheel Drive) - No visible
damage, no evidence of leakage. Drive hubs
should be one half full of EPGL SAE 90.
42. Steer Spindle, Right Front - No loose or missing
parts, no visible damage, evidence of proper lubri-
cation.
43. Leveling Jack, Right Front (If Equipped) - No loose
or missing parts, no visible damage. No cylinder
leaks or damage.
44. Drive and Lift Cutout Switches (If Equipped) - No
visible damage, properly secured.
45. Platform Controls - Properly secured, no loose or
missing parts, no visible damage. Placards secure
and legible, control switches return to neutral. Con-
trol markings legible, manual in manual storage
box.
46. Manual Descent Cable - Properly secured, no loose
or missing parts, no visible damage.
Figure 2-3. Walk-Around Inspection Points (Sheet 2 of 2)