JLG 40RTS Operator Manual User Manual
Model, Operators & safety
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- FOREWORD
- Section 1. SAFETY PRECAUTIONS
- 1.1 General
- 1.2 Pre-operation
- 1.3 Operation
- 1.4 Towing, Lifting, and Hauling
- 1.5 Additional Hazards / Safety
- Section 2. preparation and inspection
- 2.1 General
- 2.2 Preparation for Use
- 2.3 Delivery and Periodic Inspection
- Handrail Assemblies
- Platform Assembly
- Sizzor Arms
- Electrical Cable
- Pivot Pins
- Lift Cylinder
- Frame
- Drive Hubs
- Tire and Wheel Assemblies
- Sliding Wear Pad Blocks
- Hydraulic Oil Supply
- Steer Cylinder
- Steer Linkage
- Steer Spindle Assemblies
- Control Boxes. (Console and Ground)
- Battery
- Engine
- Hydraulic Pump and Valves
- Platform Placards
- Lock-Out Cylinders (If Equipped)
- 2.4 Daily Walk-around Inspection
- 2.5 Daily Functional Check
- 2.6 Lock-out Cylinder Check - (If Equipped)
- 2.7 Dual Fuel System
- 2.8 Torque Requirements
- Section 3. user responsibilities and machine control
- Section 4. machine operation
- Section 5. emergency procedures
- 5.1 General
- 5.2 Emergency Towing Procedures
- 5.3 Emergency Controls and their Locations
- Emergency Stop Switch
- Ground Control Station
- Manual Descent - (Engine/Pump Failure - Platform Controls)
- Manual Descent - (Engine/Pump Failure - Ground Controls)
- Manual Descent - (Complete Loss of Power)
- Use of Ground Controls
- Operator Unable to Control Machine
- Platform Caught Overhead
- Righting of Tipped Machine
- Post-Incident Inspection
- Section 6. INSPECTION AND REPAIR LOG