JLG 15AMI Operator Manual - Manual (Page 29)

SECTION 3 - MACHINE CONTROLS & INDICATORS
3121212 – JLG Lift – 3-1
SECTION 3. MACHINE CONTROLS & INDICATORS
3.1 GENERAL
SINCE THE MANUFACTURER HAS NO DIRECT CONTROL OVER
MACHINE APPLICATION AND OPERATION, CONFORMANCE WITH
GOOD SAFETY PRACTICES IN THESE AREAS IS THE RESPONSIBILITY
OF THE USER AND HIS OPERATING PERSONNEL.
This section provides the necessary information needed to under-
stand control functions. Included in this section are the operating
characteristics and limitations, and functions and purposes of con-
trols and indicators. It is important that the user/operator read and
understand the proper procedures before operating the machine.
These procedures will aid in obtaining optimum service life and
safe operation.
3.2 CONTROLS AND INDICATORS
Ground Control Station
(See Figure 3-1.)
NOTE: When the machine is shut down for overnight parking or
battery charging, be sure the POWER ON/OFF KEY
SWITCH is positioned to OFF to prevent draining the bat-
teries.
1. POWER ON/OFF Key Switch
A key operated power on/off switch located on the ground
control station panel controls power to all functions on the
unit. The machine will not operate without the key inserted
and turned to the ON position. When left unattended
removing key will prevent unauthorized machine use.
2. EMERGENCY STOP Button
An emergency stop (RED button) is mounted on both the
ground control station and the platform control panel.
When the button is depressed, all machine functions will
stop. To reactivate power to the machine, turn emergency
stop button clockwise until button is reset.