JLG 3246ES Operator Manual - Manual (Page 104)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
6-12 – JLG Lift – 3121165
Oil Check Procedure (1)
• Lube Point(s) - FIll Plug
• Capacity:
• Lube - Hydraulic Oil
• Interval - Every 6 months
1. With the scissor lift on a flat and level surface and the
platform empty, elevate machine and swing safety prop
out of it’s stowed position.
2. Continue to elevate the platform until the fill plug,
located on the right side of the tank attached to the lift
cylinder, is fully accessible.
ENSURE THE SCISSOR ARMS ARE PROPERLY SUPPORTED.
NOTE: The 2630ES/2646ES/3246ES platforms will have to be
raised higher than the 1930ES and 2030ES in order to
access the oil plug.
.
3. Wipe all dirt and debris from the filler plug area.
4. Slowly remove the fill plug venting any pressure that
may be built up in the reservoir.
5. To check the oil level, lower platform so it rests on the
safety prop.
THERE MAY BE UP TO 10 PSI OF PRESSURE IN THE TANK.
1930ES/2030ES/2630ES 2646ES/3246ES
2 Gal. (7.6 L) 3 Gal. (11.3 L)