JLG 3246ES Operator Manual - Manual (Page 36)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROLS
3-6 – JLG Lift – 3121165
NOTE: The platform control indicator panel uses different shaped
symbols to alert the operator to different types of opera-
tional situations that could arise. The meaning of those
symbols are explained below.
1. Indoor (CE) / Zone A Capacity (ANSI/AUS) - This indica-
tor light will be illuminated when the Indoor (CE) or
Zone A (ANSI/AUS) capacity is selected.
2. Outdoor (CE) / Zone B Capacity (ANSI/AUS) - This indi-
cator light will be illuminated when the Outdoor (CE)
or Zone B (ANSI/AUS) capacity is selected.
3. System Distress Indicator - This indicator will light up
with a fault flash code that will determine where a
problem, within the system, exists.
4. Battery Discharge Indicator (BDI) - This set of lights is
designed to let the operator know the condition of
the batteries.
5. Tilt Indicator Warning Light - A red warning light on
the control panel that illuminates when the chassis is
on a slope greater than what the machine is pro-
grammed for.
6. Overload Indicator (If Equipped) - Indicates the plat-
form has been overloaded. An audible alarm will also
signal when the platform is overloaded.
NOTE: If the Overload Indicator is illuminated, all functions will
be prevented from the platform controls. Using the
ground controls or manual descent, fully lower the
machine and reduce the weight in the platform so as to
not exceed the rated workload indicated on the capacity
decal.
7. Capacity Select Switch - On model 2630ES/3246ES
machines this switch is used to choose allowable
capacity zone. On all CE machines, except the 2630ES,
this switch is used to select either indoor or outdoor
capacity zone.
Indicates a potentially hazardous situation, which if
not corrected, could result in serious injury or death.
This indicator will be red.
Indicates an abnormal operating condition, which if
not corrected, may result in machine interruption or
damage. This indicator will be yellow.
Indicates important information regarding the operat-
ing condition, i.e. procedures essential for safe opera-
tion. This indicator will be green with the exception of
the capacity indicator which will be green or yellow
depending upon platform position.