JLG 3246ES Operator Manual - Manual (Page 105)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3121165 – JLG Lift – 6-13
6. With the plug removed, the oil level should be com-
pletely full, at the top of the fill port with scissor arms
resting on the safety prop. from the fill port.
7. If additional oil is required, add proper grade of oil by
using a funnel with a flexible spout or a plastic squeeze
bottle. Fill until oil weeps out of opening.
NOTE: Care should be taken not to introduce any impurities (dirt,
water etc.) while plug is removed.
8. Replace plug and torque to 40 ft lbs (56 Nm).
9. Any time a hydraulic component is removed or replaced,
cycle the scissor arms several times and refer to steps 3
and 4 to recheck oil level.
Lower (2) & Upper Slide Pads (3)
Lube - White Lithium Grease
Interval - Every 6 months
1. With the platform empty, elevate machine and swing
safety prop out of it’s stowed position.
ENSURE THE SCISSOR ARMS ARE PROPERLY SUPPORTED.
2. Locate the Lower and Upper Slide Pads and remove all
dirt and debris from the slide channel area (1, 2). Refer to
Figure 6-2., Lower Slide Pad Channel.