JLG 3246ES Operator Manual - Manual (Page 54)

SECTION 4 - MACHINE OPERATION
4-4 – JLG Lift – 3121165
Fold-Down Rails
DO NOT RAISE PLATFORM WITH RAILS FOLDED DOWN. THE RAILS MUST BE
IN THE UPRIGHT POSITION AND PROPERLY PINNED WHEN RAISING THE
PLATFORM.
NOTE: The rails must only be folded down when the machine is in
the stowed (fully lowered) position.
NOTE: Ensure that the drywall gate at the rear of the machine is
up and locked in position.
Platform control box should be removed and placed on
the platform with rails folded down.
1. To fold down the rails, remove the four (4) bail pins at
the two front corners and center of the rails.
2. Taking a firm hold on the top rails, carefully push for-
ward and lower until the top rail rests on the middle
rail.
3. To raise the rails back to the upright position, firmly
pull the rails toward the back of the machine and
replace the bail pins into the rails. Return drywall gate
to the lowered position.
AFTER THE RAILS HAVE BEEN FOLDED DOWN, USE EXTREME CAUTION WHEN
EXITING AND ENTERING THE PLATFORM.
BAIL PINS