JLG 3246E2 Operator Manual - Manual (Page 24)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3-4 – JLG Lift – 3120854
DO NOT OPERATE MACHINE IF HIGH DRIVE SPEED OPERATES
WHEN PLATFORM IS RAISED ABOVE THE STOWED POSITION.
NOTE: The machine is equipped with a Pothole Protection
System which lowers automatically when the plat-
form is raised. The Pothole Protection System will
also lower when either of the doors are opened, but
only on the side of the opened door and this will not
provide tip over protection. If the Pothole Protection
System does not fully lower, the DRIVE function is
cut out until the platform is completely lowered.
7. Tilt Alarm Warning Horn.(If Equipped)
The Tilt Alarm Warning is activated by the Tilt Alarm
Switch when the chassis is on a slope. See Figure 3-
1, Tilt, for degree of tilt per model.
IF TILT ALARM IS ON WHEN PLATFORM IS RAISED, LOWER
PLATFORM COMPLETELY, THEN REPOSITION MACHINE SO
THAT IT IS LEVEL BEFORE RAISING PLATFORM.
8. Tilt Alarm Warning Light. (If Equipped)
A red warning light on the control box panel will illu-
minate when the chassis is on a slope. See Figure 3-
1, Tilt, for degree of tilt per model
9. Horn. (If Equipped)
This push button switch, when activated, permits the
operator to warn jobsite personnel when the
machine is operating in the area.
10. Battery Discharge Indicator
The battery discharge indicator is a gauge that pro-
vides a visual indication of the condition of the bat-
teries.
Figure 3-2. Platform Control Station - Non Proportional Control
Table 3-1. Tilt
1932E2/2032E2 2632E2/2646E2/3246E2
1.5 Degrees 2 Degrees