JLG T500J Operator Manual - Manual (Page 39)

SECTION 3 - TOWING
3121197 – JLG Lift – 3-7
3.5 ENGAGING MANUAL LOCKOUT LEVER
NOTE: These instructions are applicable on machines S/N 0030002099
to Present.
The manual lockout lever is used to control the brake pressure
being applied to the trailer when backing up. Having the actuator
in the extended position will make it easier to engage the lockout
lever. To engage the lockout lever, move the lever back and
upwards until the front of the lever nests into the round spacer as
shown below. This will prohibit movement of the actuator when
backing up. The lockout lever will move to the towing position
when you drive forward again.
3.6 TRAILER MANEUVERING
The hazards and risks of injury are also much greater than when
driving without a trailer. Driving a vehicle with a trailer in tow is
different from driving without a trailer in tow. Acceleration,
maneuverability and braking, are all lessened with a trailer in tow.
Spend time adjusting to the different feel and maneuverability of
the tow vehicle with a trailer.
3.7 TOWING GUIDELINES
• Before towing, check coupling, safety chain, safety brake,
tires, wheels and lights.
• Check the lug nuts or bolts for tightness.
• Check coupler tightness after towing 50 miles (80.5 km).
• If equipped with electric brakes, adjust the brake control-
ler to engage the trailer brakes before the tow vehicle
brakes.
• Be aware of the width of the trailer. This is important when
turning, passing, and pulling next to a curb.
• Be aware of the height of the trailer, especially when
approaching roofed areas and around trees.
DO NOT TOW IF LOCK-OUT
LEVER IS ENGAGED
LIFT LEVER TAB TO
ENGAGE LOCKOUT