JLG T500J Operator Manual - Manual (Page 45)

SECTION 4 - MACHINE CONTROLS AND INDICATORS
3121197 – JLG Lift – 4-1
SECTION 4. MACHINE CONTROLS AND INDICATORS
4.1 GENERAL
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE APPLICATION AND
OPERATION. THE USER AND OPERATOR ARE RESPONSIBLE FOR CONFORMING WITH
GOOD SAFETY PRACTICES.
NOTE: On all battery powered machines:
If at any time during operation the machine is idle for a period
exceeding 30 minutes, the emergency stop switch(es) must be
recycled to start the machine again.
This section provides the necessary information needed to
understand control functions.
4.2 CONTROLS AND INDICATORS
NOTE: All machines are equipped with control panels that use symbols
to indicate control functions.
NOTE: The indicator panels use different shaped symbols to alert the
operator to different types of operational situations that could
arise. The meaning of those symbols are explained below.
Indicates a potentially hazardous situation, which if
not corrected, could result in serious injury or death.
This indicator will be red.
Indicates an abnormal operating condition, which if
not corrected, may result in machine interruption or
damage. This indicator will be yellow.
Indicates important information regarding the oper-
ating condition, i.e. procedures essential for safe oper-
ation. This indicator will be green with the exception of
the capacity indicator which will be green or yellow
depending upon platform position.