JLG T500J Operator Manual - Manual (Page 66)

SECTION 5 - MACHINE OPERATION
5-12 – JLG Lift – 3121197
5.9 BATTERY CHARGING
NOTE: Be sure that machine is parked in a well ventilated area before
charging.
ONLY PLUG THE CHARGER INTO A PROPERLY GROUNDED OUTLET. DO NOT USE
GROUND ADAPTORS OR MODIFY PLUG. DO NOT TOUCH NON-INSULATED PORTION OF
OUTPUT CONNECTOR OR NON-INSULATED BATTERY TERMINAL.
ALWAYS DISCONNECT THE AC SUPPLY BEFORE MAKING OR BREAKING THE CONNEC-
TIONS TO THE BATTERY.
DO NOT OPEN OR DISASSEMBLE CHARGER.
DO NOT OPERATE CHARGER IF THE AC SUPPLY CORD IS DAMAGED OR IF THE CHARGER
HAS BEEN DAMAGED IN ANY WAY.
1. The battery charger AC input plug is located at the rear of
the machine. Connect the charger AC input plug to a
grounded outlet.
If the machine is equipped with an optional generator, the
battery charger can be plugged into the generator outlet.
See Figure 5-5.
2. When powered up the charger will go through a short self-
test. The battery charger lights on the Ground Control Sta-
tion will flash in sequence for two seconds.
3. The batteries are fully charged when the green light on the
battery charger status panel is illuminated.
NOTE: If the charger is left plugged in, the charger will automatically
restart a complete charge cycle if the batteries voltage drops
below a minimum voltage or 30 days has elapsed.