JLG T500J Operator Manual - Manual (Page 72)

SECTION 5 - MACHINE OPERATION
5-18 – JLG Lift – 3121197
Never drag any part of the material on the ground or use the
boom to pull sideways. The load must be freely suspended.
Keep the material hook and tethered remote control cable
stowed in the proper location when not in use.
5.14 ACCESSORY TRAY
ANY TOOL PLACED ON THE ACCESSORY TRAY MUST BE PROPERLY SECURED AND NOT
LOOSE.
The accessory tray is intended to hold tools such as a compressor,
generator, or pressure washer. Capacity of the tray is 250 lbs. (114
kg) or a weight which does not exceed the axle rating or GVW rat-
ing, whichever is less.
5.15 PANEL TRAY
WITH THE PANEL TRAY INSTALLED, THE ORIGINAL PLATFORM CAPACITY RATINGS
ARE REDUCED AS SPECIFIED IN TABLE 7-1. DO NOT EXCEED THE NEW PLATFORM
CAPACITY RATING. REFER TO THE CAPACITY DECAL LOCATED IN THE TRAY.
AN INCREASE OF THE AREA EXPOSED TO THE WIND WILL DECREASE STABILITY. LIMIT
PANEL AREA TO 32 SQ. FT. (3 SQ. M.)
1. Check for cracked welds and damage to the tray. Make sure
the tray is properly secured to the platform.
2. Check for loose nuts and bolts.
3. Check to ensure the strap is not torn or frayed.
4. Replace torn or frayed straps, bent or crushed tray parts,
missing or illegible decals.
5. When operating, make sure no personnel are beneath the
platform.
6. Remove the tray when not in use.