JLG T500J Operator Manual - Manual (Page 74)

SECTION 5 - MACHINE OPERATION
5-20 – JLG Lift – 3121197
5.16 DRIVE & SET
DO NOT DRIVE THE MACHINE ON GRADES OR SIDESLOPES EXCEEDING THOSE LISTED
IN TABLE 7-1.
NOTE: When the boom is raised out of the stowed position, drive will be
cut out.
To Set Up The Machine for Drive & Set Operation:
1. Place the boom in the stowed position (fully retracted, fully
lowered, over the trailer tongue).
2. Set the parking brake (ANSI brake shown). Refer to the park-
ing brake decal on the tongue.
3. Release the boom latch.
4. Make sure the tongue jack is extended enough to allow
installation of the jockey wheel.
5. Remove the pin securing the jockey wheel in the stowed
position and swing the wheel down into the drive position.
Secure the wheel in place with the retaining pin.