JLG 260MRT ANSI Parts Manual - Manual (Page 105)

3121109 260MRT 4-17
SECTION 4 PLATFORM
FIGURE 4-5. DRIVE/STEER P/Q CONTROLLER ASSEMBLY (PRIOR TO S/N 0200142023)
ITEM # PART NUMBER QTY. DESCRIPTION REV.
1600308 Ref. CONTROLLER ASSEMBLY D
Ref. Note: If your machine was equipped with a 1600308 P/Q
controller, when ordering a replacement controller you must
order a 1600308 P/Q controller. You can not replace the
1600308 P/Q controller with the 1600403 J.R Merritt control-
ler.
7020527 1 Mechanical Assembly
1 7020503 1 Handle/Housing Assembly
1A 7020520 1 Boot
1B 7020504 1 Plate, Mounting
1C 7020502 1 Gasket
1D 7020528 1 Screw #10-24NC x 3/8in
2 7020529 1 Grip Assembly
2A 7020501 1 Push Button
7020530 1 Push Button w/Wires
2B 7020500 1 Switch, Micro
2C Use 7020541 1 Grip - Right Half (was p/n 7020531)
2D Use 7020541 1 Grip - Left Half (was p/n 7020532)
Ref. Note: P/N 7020541 includes both Right Side & Left Side
Handle Halves.
2E 7003791 1 Actuator, Switch
2F 7011997 1 Trigger
2G 7003790 1 Cap, Rubber
3 7020533 1 Electrical Assembly
7020535 2 Resistor
3A 7020509 1 Plate, Mounting - Potentiometer
3B 7020534 1 Potentiometer
3C 7011940 1 Gear, Pinion
3D 7020511 1 Setscrew #6-32 x 1/8in
4460265 1 Plug, Male - 9 Pin (Not Shown)
4460268 8 Socket, Female (Not Shown)
4460266 1 Connector, Receptacle - 9 Pin (Not Shown - Part of Console
Harness)
4460267 8 Pin, Male (Not Shown - Part of Console Harness)