JLG 260MRT ANSI Parts Manual - Manual (Page 107)

3121109 260MRT 4-19
SECTION 4 PLATFORM
FIGURE 4-6. DRIVE/STEER J.R. MERRITT CONTROLLER ASSEMBLY (S/N 0200142023 TO
PRESENT)
ITEM # PART NUMBER QTY. DESCRIPTION REV.
1600403 Ref. CONTROLLER ASSEMBLY F
Ref. Note: If your machine was equipped with a 1600403
J.R. Merritt controller, when ordering a replacement control-
ler you must order a 1600403 J.R. Merritt controller. You can
not replace the 1600403 J.R. Merritt controller with the
1600308
P/Q controller.
1 70000081 1 Potentiometer
2 7027367 1 Switch, Push Button (Not Shown - Located Behind #3)
3 7027765 1 Lever, Enabler
4 7027766 1 Ring, Retaining
5 70000082 1 Microswitch
6 70000083 1 Coupler, Microswitch
7 70000084 1 Cap, Rubber
8 7027365 1 Actuator, Switch
9 70000085 1 Boot, Rubber
10 4460265 1 Plug, Male - 9 Pin
11 4460226 8 Socket, Female
12 70000685 A/R Washer, Plastic (Not Shown)
13 70000684 A/R Screw, Handle (Not Shown)
14 Not Available A/R Nut, Handle (Not Shown)
15 70000683 A/R Washer, Neoprene (Not Shown)
16 70000686 A/R Screw, Handle (Not Shown)
17 4460266 1 Connector, Receptacle - 9 Pin (Not Shown - Part of Console
Harness)
18 4460267 8 Pin, Male (Not Shown - Part of Console Harness)
19 70004194 1 Return Spring Kit
— — — — — — — — —
70003650 1 Handle Repair Kit (Includes handle gasket, push button, lever,
front handle half, back handle half, top actuator, boot and
hardware.