JLG 2505H Operator Manual - Manual (Page 74)

Section 4 - Operation
4-10 31200743
4.4 ROAD OPERATION (2505H)
1. Preparation
a. Remove load from attachment.
b. Remove any large amounts of dirt from machine.
c. Check lights and mirrors and adjust if necessary.
Note: Be sure to follow all local and federal/provincial traffic regulations.
2. Lower boom. Lowest part of attachment should be approximately 12 in (30 cm)
above the ground.
3. Fully tilt attachment back.
4. Place protective shield over front bucket edge: remove or reposition carriage
forks toward the machine and secure to the carriage.
5. Change steer mode to front wheel steering (1). See “Steer Mode Change” on
page 3-20.
6. Activate road use operation switch (2) to lock steer mode and joystick controlled
functions.
7. Machine is now ready for road operation.
OAL2070
2 1