JLG 2658E3 ANSI Operator Manual User Manual
Models, Operation and safety manual
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Service & Maintenance Manual
- TABLE OF CONTENTS
- SUBJECT - SECTION, PARAGRAPH PAGE NO.
- LIST OF FIGURES
- FIGURE NO. TITLE PAGE NO.
- LIST OF TABLES
- TABLE NO. TITLE PAGE NO.
- 1.1 General
- 1.2 Pre-operation
- 1.3 Operation
- 1.4 Towing, Lifting, and Hauling
- 1.5 Additional Hazards / Safety
- Section 2. Machine preparation and inspection
- 2.1 General
- 2.2 Preparation For Use
- 2.3 Delivery and Frequent Inspection
- Handrail Assemblies
- Platform Assembly
- Sizzor Arms
- Electrical Cable
- Pivot Pins
- Lift Cylinder
- Frame
- Tire and Wheel Assemblies
- Sliding Wear Pad Blocks
- Hydraulic Oil Supply
- Steer Cylinder
- Steer Linkage
- Front Spindle Assemblies
- Control Boxes (Platform and Ground)
- Batteries
- Motor/Pump Unit and Valves
- Platform Placards
- 2.4 Daily Walk-Around Inspection
- 2.5 Daily Functional Check
- 2.6 Torque Requirements
- 2.7 Battery Charging
- Section 3. User Responsibilities and machine control
- Section 4. machine operation
- 4.1 Description
- 4.2 General
- 4.3 Motor Operation
- 4.4 Raising and Lowering (Lifting)
- 4.5 Platform Extension
- 4.6 Steering
- 4.7 Traveling (Driving)
- 4.8 Parking and Stowing
- 4.9 Platform Loading
- 4.10 Safety Prop
- 4.11 Transporting, Tie Down and Lifting
- 4.12 Towing
- Section 5. emergency procedures
- 5.1 General
- 5.2 Emergency Towing Procedures
- 5.3 Emergency Controls and Their Locations
- 5.4 Emergency Operation
- 5.5 Incident Notification
- Section 6. INSPECTION AND REPAIR LOG