JLG 2658E3 ANSI Operator Manual - Manual (Page 25)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3120761 – JLG Sizzor – 3-5
switch is pressed. If the joystick is not activated
within 3 seconds, the drive switch must be pressed
again before activating the joystick. When the joy-
stick is returned to the center off position, the opera-
tor has 3 seconds to re-activate the joystick or select
another function before power is removed by the
enable circuit. In addition, the posi-trac switch can
be engaged while operating the drive function to
give a more evenly distributed oil flow to each drive
motor. Do not try to operate the drive, lift, and pow-
ered deck extension functions simultaneously. If the
drive, lift, and powered deck extension functions are
selected simultaneously, no function will operate. If
this occurs, pause, then press only one of the func-
tion switches to activate the function.
NOTE: If the machine is equipped with the optional powered
deck extension, the Drive function is cut out when
the deck is extended with the platform raised above
the stowed position.
As an option, Models 2033E3 and 2646E3 may be
equipped for 1,000 lb. (455 kg) platform capacity.
When equipped for 1,000 lb. (455 kg) platform
capacity, Model 2033E3 cuts out the DRIVE function
at a platform height of 17 feet (5.2 m) and Model
2646E3 cuts out the DRIVE function at a platform
height of 19 feet (5.8 m).
The machine is equipped with a Pothole Protection
System which lowers automatically when the plat-
form is raised. If the Pothole Protection System does
not fully lower, the Drive function is cut out until the
platform is completely lowered.
7. High Drive Speed Switch - The high drive speed
switch, when used in conjunction with the joystick
being operated in the drive mode, provides addi-
tional oil flow to the drive circuit for increased travel
speed. To operate high drive, depress the high drive
speed switch either simultaneously with the drive
switch or while operating the drive function.
DO NOT USE HIGH DRIVE SPEED WHEN DRIVING IN
CLOSE QUARTERS OR WHEN DRIVING IN REVERSE.
IF HIGH DRIVE IS SELECTED WHEN OIL TEMPERA-
TURE IS VERY COLD (BELOW 40° F.) HIGH DRIVE WILL
NOT ENGAGE IMMEDIATELY. AS OIL WARMS (ABOVE
40° F.) IF HIGH DRIVE IS SELECTED, IT WILL ENGAGE
AUTOMATICALLY WHILE DRIVING.
Figure 3-3. Platform Control Station - All Models