Connection, Connecting a computer or monitor, Connecting a computer – BenQ MP610 User Manual
Page 21
Connection
15
Connection
When connecting a signal source to the projector, be sure to:
1.
Turn all equipment off before making any connections.
2.
Use the correct signal cables for each source.
3.
Ensure the cables are firmly inserted.
In the connections shown below, some cables may not be included with the
projector (see
). They are commercially available
from electronics stores.
Connecting a computer or monitor
Connecting a computer
The projector provides a VGA input socket that allows you to connect it to a laptop or
desktop computer.
Additionally, you can also connect the projector to a computer via the USB cable so you can
perform paging operations of the application on the PC or notebook. (see
).
To connect the projector to a laptop or desktop computer:
1.
Take the supplied VGA cable and connect one end to the D-Sub output socket of the
computer.
2.
Connect the other end of the VGA cable to the D-SUB/COMP IN signal input socket
on the projector.
3.
If you wish to use the remote paging function (see
), take the supplied USB cable and connect the larger end to the USB port of
the computer, and the smaller end to the USB socket on the projector.
4.
Take a suitable audio cable and connect one end of the cable to the audio output
socket of the computer, and the other end to the Audio socket of the projector.
The final connection path should be like that shown in the following diagram:
Laptop or desktop computer
USB cable
Audio cable
VGA cable