BenQ MP610 - Manual (Page 37)

Operation 31
2. Pro-Picture menu
Some picture adjustments are available only when certain input sources are in use.
Unavailable adjustments are not shown on the screen.
FUNCTION
(default
setting / value)
DESCRIPTION
Auto Resize
(on)
Automatically resizes the input signal pixel resolution to the native resolution
of the projector.
On: The pixel resolution of the input signal is converted to the native
resolution of the projector (800 x 600). For input signals with lower
resolutions, gaps in the pixels are automatically interpolated into the image
before being projected. This may distort the image clarity.
Off: The image is projected as its original resolution, with no pixel conversion.
For input signals with lower resolutions, the projected image will display
smaller than if resized to full screen. You could adjust the zoom setting or move
the projector towards the screen to increase the image size if necessary. You
may also need to refocus the projector after making these adjustments.
Aspect Ratio
(4:3)
There are two aspect ratio settings.
1. 4:3 (for a standard screen) 2. 16:9 (for a wide screen)
16:9 aspect ratio is only sourced through the Component Video input
when being fed an appropriate 16:9 aspect signal. See
"Connecting a
Component Video source device" on page 18 and "Obtaining a
preferred projected image size" on page 12 for details.
H Position
(0)
Adjusts the horizontal position
of the projected image.
V Position
(0)
Adjusts the vertical position of
the projected image.
Phase
(depends on
the selected
input
source)
This function allows you to adjust the clock phase
to reduce image distortion.
H Size (0)
Adjusts the horizontal width of the image.
Sharpness
(15)
Adjusts the image to make it look sharper or softer.
-30 +30
-30 +30