JLG M400 ANSI Service Manual - Manual (Page 173)

SECTION 5 - HYDRAULICS
3121125 – JLG Lift – 5-19
22. If applicable, install the cartridge-type holding valve
and fittings in the rod port block, using new o-rings
as applicable. (See Table 5-3, Holding Valve Torque
Specifications).
IF THE CYLINDER IS TO BE TESTED PRIOR TO INSTALLATION ON
THE MACHINE, EXTREME CARE SHOULD BE USED TO INSURE
THAT THE OUTER END OF THE ROD IS SUPPORTED. USE EITHER
A TRAVELING OVERHEAD HOIST, FORK-LIFT, OR OTHER MEANS
TO SUPPORT THE OVERHANGING WEIGHT OF THE EXTENDING
ROD.
Table 5-1.Cylinder Head and Tapered Bushing Torque
Specifications
Description
Head Torque Value
(Wet)
Tapered Bushing
Torque Value (Wet)
Jib. Cylinder
41 Nm
(30 ft. lbs.)
7 Nm
(5 ft. lbs.)
Level Cylinder
41 Nm
(30 ft. lbs.)
7 Nm
(5 ft. lbs.)
Master Cylinder
41 Nm
(30 ft. lbs.)
7 Nm
(5 ft. lbs.)
Master Cylinder
E/M400A,E/M450A,
108 Nm
(80 ft. lbs.)
N/A
Table 5-2. Cylinder Piston Nut Torque Specifications)
Description
Nut Torque
Valve (Wet)
Setscrew
Torque Value
(Dry)
Upper
Lift Cylinder 200 ft. lbs.
(270Nm)
100 in. lbs.
(11 Nm)
Mid
Lift Cylinder 400 ft. lbs.
(542 Nm)
100 in. lbs.
(11 Nm)
Mid
Lift Cylinder
E400An 200 ft.lbs.
(270 Nm)
100 in. lbs
11 (Nm)
Lower
Lift Cylinder 400 ft. lbs.
(542 Nm)
100 in. lbs.
(11 Nm)
Table 5-3. Holding Valve Torque Specifications
Description Torque Value
SUN - 7/8 HEX M20 X 1.5 THDS. 30-35 ft. lbs.
(41-48 Nm)
SUN - 1 1/8 HEX 1 -14 UNS THDS. 45-50 ft. lbs.
(61-68 Nm)
SUN - 1 1/4 HEX M36 X 2 THDS. 150-160 ft. lbs.
(204-217 Nm)
RACINE - 1 1/8 HEX 1 1/16 - 12 THDS. 50-55 ft. lbs.
(68-75 Nm)
RACINE - 1 3/8 HEX 1 3/16 - 12 THDS. 75-80 ft. lbs.
(102-109 Nm)
RACINE - 1 7/8 HEX 1 5/8 - 12 THDS. 100-110 ft. lbs.
(136-149 Nm)