JLG M450 Operator Manual - Manual (Page 100)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6-10 – JLG Lift – 3121210
2. Swing Bearing/Worm Gear Teeth
Lube Point(s) - Grease Fittings
Capacity - Spray On
Lube - OG or Mobiltac375NC
Interval - A/R
Comments - If necessary install grease fittings into worm
gear housing and grease bearings.
NOTE: OG will allow better cycle times than Mobiltac375NC,
however Mobiltac375NC must be used in dusty environ-
ments. If the swing function becomes noisy and/or rough
lubricate the bearing teeth.
DO NOT OVERGREASE BEARINGS. OVERGREASING BEARINGS WILL
RESULT IN BLOWING OUTER SEAL IN HOUSING.