JLG 2658E3 ANSI Service Manual - Manual (Page 31)

SECTION 2 - PROCEDURES
3120762 – JLG Lift – 2-19
Steer Adjustment
1. If necessary, connect a pressure gauge to gauge
port MP.
2. Activate drive by pressing the drive switch and acti-
vating the controller to the full forward position.
While holding the controller, activate steer right and
check steer right pressure. If necessary, adjust steer
right pressure to 2100 psi (145 bar).
3. Activate drive by pressing the drive switch and acti-
vating the controller to the full forward position.
While holding the controller, activate steer left and
check steer left pressure. If necessary, adjust steer
left pressure to 2100 psi (145 bar)..
Figure 2-19. Pressure Setting Adjustments