IOGear GHE125C - Manual (Page 13)

11
If you purchased the enclosure model (GHE125C), please follow these instructions to install your 2.5" Hard Disk
Drive. OTHERWISE, PROCEDE TO PAGE 17.
WARNING: Opening ION Drive’s with built in Hard Drives (GHD125C40, GHD125C60, etc...) WILL VOID YOUR
WARRANTY. For assistance with your hard drive, please contact your IOGEAR service support representative.
Hardware Installation:
Attention! Please take all proper Electro Static Discharge (ESD) precautions during the installation of your new
hardware. For further information on ESD please visit http://www.esda.org.
Installation of Hard Drive
Step 1.
Before you begin, please have a Phillip’s head
screw driver available.
Step 2.
Unscrew the top two screws of the ION Drive.