Echo SRM-225U Serial S79012001001 - S79012004905 - Manual (Page 13)

G
rass
T
rimmer
/B
rush
C
uTTer
O
peraTOr
'
s
m
anual
13
A
u
-
handle InstallatIon
Tools Required: 17 & 19 mm wrench, Torx T27 L-Wrench,
Parts Required: U-Handle, Clamp w/screws, 8 mm x 55 mm hex
bolt, 8 mm flat washer
1. Install upper U-Handle and bracket on lower bracket with one
(1) 8mm x 55mm bolt (A) and (1) large circular washer. Do not
tighten bolt securely until final adjustments are completed.
2. Loosen upper (2) U-handle clamp screws (B), and position U-
handle as shown.
3. Lightly tighten 8mm bolt (A) and clamp screws (B) to hold U-
handle in position until final adjustments are completed.
4. Route throttle linkage and ignition lead assembly along shaft and
clip as shown.
B
throttle lInkage and IgnItIon leads
1. Close choke and remove air filter cover.
2. Place throttle linkage (A) into adjustment fixture (B) and install
wire end into large carburetor throttle swivel hole (C). Check
throttle for freedom of movement and that wide open throttle / low
idle extremes are adjusted properly. The throttle linkage must be
adjusted by moving the adjustment nut (D). Consult with your
Echo Dealer for correct adjustment procedure.
4. Tighten nut (E).
5. Connect 2 ignition stop leads F,G) from throttle cable tubing to 2
ignition leads (F,G) on engine.
A
B
C
F
G
H
D
E