Echo CH9540H Owners Manual v.3 - Manual (Page 23)

PTO CHIPPERS 19
ENGLISH
Section
TRoubLESHooTING
6
Before performing any of the corrections in this troubleshooting chart, refer to the appropriate information contained in
this manual for the correct safety precautions and operating or maintenance procedures. contact your dealer or the
factory for service problems with the machine.
pRobLEm poSSIbLE CauSES REmEdY
Rotor stalls or
stops.
Obstructed discharge. Use branch or similar object to clear discharge.
Plugged rotor. clear rotor. Feed material more evenly.
Feeding material that is too large. Reduce size of material.
chipper does not
chip.
dull chipper blades. Rotate or sharpen blades.
drive belts loose or worn. Inspect drive belts, adjust or replace if needed.
Attempting to feed branches that
are too large.
limit branch size to x inches in diameter.
Broken or missing chipper blades Replace blade.
hard to feed
chipper; requires
excessive power to
chip.
dull chipper blades. Reverse or sharpen blades.
Obstructed discharge. Use branch or similar object to clear discharge.
Improper blade clearance. Adjust clearance between chipper anvil and chipper blades.
Shredder requires
excessive power or
stalls.
Obstructed discharge. Use branch or similar object to clear discharge.
Plugged rotor. clear rotor, feed material into shredder more evenly.
Wet or green material will not
discharge.
Alternately feed dry material or install larger discharge screen.
Belt squeals when
engaging clutch.
engaging clutch too fast. engage clutch more slowly.
Plugged rotor. clear rotor. Feed material more evenly.
Belt tension too loose. Replace belt or spring.
Material from
chipper wraps
around rotor shaft
Stringy, green material bypasses
chipper blades.
Rotate branch or material when feeding to cut completely.
dull chipper blades. Sharpen blades.
Improper blade clearance. Adjust clearance between anvil and chipper blades.
excessive vibration
while running.
drive system vibration.
check drive belts and pulleys for bad or worn areas. check for dull
chipper blades or shredder knives.
Rotor out of balance.
Inspect rotor for broken or missing chipper blades and shredder
knives; replace if needed. check rotor to see if it wobbles. check
to see if rotor is assembled correctly.
chipper blade to anvil clearance is
incorrect.
Set chipper blade/anvil clearance to recommended distance (1/16” to
1/8”).
Rotor will not turn.
drive belt too loose or broken. Replace belt or spring.
Obstructed discharge. Use branch or similar object to clear discharge.
Plugged rotor. clear rotor. Feed material more evenly.
cannot engage
clutch.
Improper belt installation; belt not
under belt guide.
Install belt properly; install belt under belt guide.
Improper belt tension. Adjust belt tension. Replace belt or spring if needed.
excessive belt wear.
Not using correct belt.
contact your nearest authorized dealer to order the correct belt for
your chipper/shredder.
Pulley(s) damaged or worn. Replace pulley(s).
Pulley(s) not in alignment. Align pulley(s) with straight edge.
Belt(s) tension too loose. Replace belt or spring.