Echo CH6614 Owners Manual v.1 - Manual (Page 12)

6 INCH CHIPPER 10
2.2 aTTach chiPPer chuTe
Remove chipper from shipping crate. Place unit on a
level surface before attempting to assemble.
Mount the chipper chute to the frame mounting bracket
using eight 3/8" x 1" bolts and locknuts (see Figure 2.2).
use three bolts on each side and two on the bottom.
Tighten bolts to 35 ft-lbs.
1.
2.
Figure 2.2, Attaching the chipper chute
Section
assemblY
2
2.1 Trailer Wheels and hiTch
Remove the chipper from its shipping crate. Place the
unit on a level surface before assembling.
Support the frame on wood blocks or other support
device.
Mount the two tires and rims to the axle assembly with
the supplied lug nuts.
Mount the trailer hitch assembly to the frame using
three 3/8" x 3-1/2" bolts and locknuts.
1.
2.
3.
4.
noTe
See the torque chart in the back of the manual for
proper tightening of bolts.
2.3 aTTach discharge Tube
attach the blower discharge tube to the chipper frame
mounting flange shown in Figure 2.3.1. Half of the
mounting clamp is already attached to the blower tube.
Slide the tube onto the flange and tighten the bolts to
secure it.
Install the second half of the spacer and clamp to the
tube and flange. Rotate the tube 360 degrees and lock
it in place with the lock pin to make sure it is mounted
correctly.
1.
2.
Figure 2.3.2, Attaching the discharge tube
Figure 2.3.1, Mount the discharge to the mounting flange
Do not operate this unit without the chipper chute
correctly installed. Rotating cutting blades can cause
serious personal injury.
Warning